Wire. See the EEPROM section for more information. Demonstrates use of the Wire library // Writes data to an I2C/TWI slave. The first byte written is the least signifcant byte of data: int myDevice. These write an 8 or 16-bit data value into the device register indicated. Write a 16-bit data value to device register regAddress. The base I2C address can also be modified by writing a new address to EEPROM. Description of the I2C library functions in wiringPi using the BCM2835 GPIO. Now when you use the Wire library, you call the TwoWire::write function which copies your data into a 2nd. This data is already sitting in an array in SRAM. On boards where the chips are embedded, there may be as many as 4 address pins, they'll be labeled with jumpers Wire works very well, but: I only need the Arduino to act as I2C master and the Wire library seems to be a real waste of resources: My goal is to send out data en bloc (e.g. On both the SAMD09 and Attiny817 breakouts, the default A0 pin is 16, default A1 pin is 17. Thus you can, with the same hardware, have up to 4 devices If both address select pins are pulled low, the I2C address is incremented by 3. If address select pin 1 ( A1) is pulled low, the I2C address is incremented by 2. If address select pin 0 ( A0) is tied to ground on boot, the I2C address is incremented by 1. new values to the register the I2C loop mode is in error write(busAddress. This address can be modified using the address select pins, there can be multiple address pins. include include // Return values of endTransmission in.However, when doing this conversion: 17/1016 + 1710 it writes correct number 17. Check the board documentation for the default base I2C address, or you can plug it in and scan the I2C bus to find it. Wire.beginTransmission (moduleaddress) Wire.write (0) Wire.write (00010111) Wire.endTransmission () You get different number, 13 or 10 (can't recall what number, I know it was wrong). LIS2DH accelerometer data sheet The device is accessed through a set of registers. The seesaw's default I2C address is initially configured in the compiled firmware (e.g for theSeeSaw breakouts we use 0x49) but other boards will have a different base address.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |